Separating CO₂ from a flue gas is only half the job. The material that binds the CO₂ has to release it again so that it can be reused, and that step, called regeneration, costs energy. How much energy is one of the figures that decide whether recycled CO₂ becomes an affordable feedstock for Power-to-X. SPIN member novoMOF AG now reports a value well below the conventional benchmark.

What has been reported

The Global CCS Institute published its annual technology compendium, «State of the Art: CCS Technologies 2026», in July 2026. It presents more than 190 technologies from over 90 companies, novoMOF among them. According to novoMOF, the compendium lists a specific regeneration energy below 1 GJ per tonne of CO₂ for the company’s industrial-scale MOF technology, which the company describes as among the lowest values for post-combustion capture.

How to read the figure

For comparison: in its Editor’s Insights on the 2025 edition, the Global CCS Institute gives 3.5 to 3.7 GJ per tonne of CO₂ as the typical reference regeneration energy for monoethanolamine (MEA), the classic amine solvent. A value below 1 GJ would be less than a third of that.

Three caveats belong next to the number.

  • The figures in the compendium are supplied by the technology providers. The Institute states that claims on performance are the responsibility of the company concerned and are not endorsed by the Institute.
  • Specific regeneration energy is not total system energy. In the Institute’s definition it is the energy needed to capture CO₂ and regenerate the technology for continuous operation, without waste heat recovery. The energy use of the complete capture system is reported separately and depends on the design.
  • novoMOF itself points out that values reported for different technologies, processes and methods may not be directly comparable.

Why it matters for Power-to-X

Every carbon-based synthetic fuel or chemical needs a CO₂ source: biogenic, atmospheric or industrial. Whichever source is used, the energy spent on capture adds to the cost of the product and competes with other uses of heat and electricity on site. A capture step that needs less energy, and that can run on low-temperature heat, makes recycled CO₂ cheaper and widens the range of sites where recycling is practical, including smaller and decentralised emitters.

The reported value will have to be confirmed in operation. novoMOF and its technology partners are now taking MOF-based capture into industrial pilots, which is where site-specific operating data will show how much of the advantage survives contact with real flue gas.

Sources: Global CCS Institute, State of the Art: CCS Technologies 2026; Global CCS Institute, Editor’s Insights 2025; novoMOF AG newsletter «Q3 Highlights», 29 October 2026. novoMOF AG is a member of SPIN.

🤖 AI transparency: This text and its visual were created using AI, reviewed and approved by a human.

Join us now — button linking to SPIN membership application

Members gain direct access to Switzerland’s cross-sector Power-to-X network of research institutes, industry leaders and policymakers — and a seat at the table shaping the country’s innovation, regulatory and technological path to defossilization.

← Back

Thank you for your response. ✨

I would like to join SPIN as
Is the organisation already a member of Swissmem?